How To Interpret The Chirps And Indicator Light Flashes; Smart Autotesting; Automatic Malfunction Bypass - Clifford concept 50 Owner's Manual

Clifford owner's manual world-class auto security concept 50
Hide thumbs Also See for concept 50:
Table of Contents

Advertisement

How to interpret the chirps and indicator light flashes

When you use the remote control, the system responds with chirps (unless the chirp muting
feature is turned on) and indicator light flashes:
Chirps and flashes
1
2
2 and then 4
Armed but one of the sensors is malfunctioning (see Smart AutoTesting on page 13)
3
Disarmed and there was an intrusion attempt (see Smart prior intrusion attempt on page 14)
4
Armed but the bonnet or boot is open (see Smart AutoTesting on page 13)

Smart AutoTesting

When remotely armed, your Concept 50 tests all triggers and sensors. If the bonnet
or boot is open when you arm, your Concept 50 will immediately alert you of the
problem by issuing 4 chirps and 4 indicator light flashes instead of the usual 2 and
2. If one of the sensors is malfunctioning, you'll receive the usual 2 chirps and
flashes, then, 5 seconds later, there will be 4 chirps and 4 flashes.
Specific malfunction identification:
malfunctioning trigger or sensor. This saves you time and money since your
installer won't have to spend hours trying to determine where the problem is:
1. When you insert your key and turn on the ignition, the LED indicator inside the
vehicle will be flashing, pause, then repeat.
2. Count the number of flashes in one cycle between pauses (for your convenience,
the flash cycle repeats 5 times) and refer to the chart below:
Number of LED flashes between pauses
1 flash
2 flashes
4 flashes
5 flashes

Automatic malfunction bypass

To provide the utmost protection even if a system component malfunctions, your
Concept 50 will automatically bypass the faulty point and arm all other triggers and
sensors until you can have the system serviced by your local Authorised Clifford
Dealer. If you accidentally armed the system with the boot or bonnet open, simply
disarm, close it, then rearm. The system will then monitor that point again.
Meaning
Your Concept 50 system is disarmed
Your Concept 50 system is armed
The system can also indicate the specific
Malfunction
Volumetric Radar Sensor
Glass Tampering Sensor
Boot trigger
Bonnet trigger
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

50uk

Table of Contents