Oven Light; Troubleshooting - Whirlpool WFG775H0HV1 User Instructions

The oven lights are 120 V, 40 W maximum halogen bulbs. They
will come on when the oven door is opened. The oven lights will
not work during the Self-Cleaning cycle.
When the door is closed, touch the appropriate Oven Light keypad
to turn on the oven light.
To Replace:
Before replacing the bulb, make sure the oven is off and cool.
1. Unplug range or disconnect power.
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service
call, refer to the warranty, or visit producthelp.whirlpool.com. In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Problem Possible Causes
Nothing will Power supply cord is unplugged.
operate
Energy Save is active,
and the display is blank.
Household fuse is blown or
a circuit breaker is tripped.
Main or regulator gas shut-off valve
is in the Off position.
The range is improperly
connected to the gas supply.
Surface The control knob is not set correctly.
burners will not
Air in the gas lines.
operate
Clogged burner ports.
Surface burner Clogged burner ports.
flames are
Burner caps positioned improperly.
uneven, yellow
and/or noisy
Range converted improperly.
Excessive
Cookware and flame are not matched.
heat around
cookware on
cooktop
16

Oven Light

TROUBLESHOOTING

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Solutions
Plug into a grounded 3 prong outlet.
Press any keypad on the control to display the time of day. See the
"Electronic Oven Controls" section for more information.
Replace the fuse or reset the circuit breaker. If the problem continues,
call an electrician.
See the Installation Instructions.
Contact a trained repair specialist or see the Installation Instructions.
Push in knob before turning to a setting.
If this is the first time the surface burners have been used, turn on any
one of the surface burner knobs to release air from the gas lines.
See the "Sealed Surface Burners" section.
See the "Sealed Surface Burners" section.
See the "Sealed Surface Burners" section.
If propane gas is being used, contact a service technician.
The cookware should be centered above the burner with the bottom
sitting level on the grate. The flame should be adjusted so that it does
not extend up the sides of the pan.
2. Unscrew the oven light globe then grasp the halogen bulb and
pull out.
3. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. To avoid damage to or decreasing the life of the new
bulb, do not touch bulb with bare fingers.
4. Replace oven light globe by screwing it back into place.
5. Reconnect power.
In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7