Oven Light; Troubleshooting - Whirlpool WFE550S0HZ User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Cooktop element cycles on
and off on High setting.
Oven will not operate
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
Self-Cleaning Cycle will not
operate
14

Oven Light

TROUBLESHOOTING

to possibly avoid the cost of a service call.
www.whirlpool.com
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown, or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is not set
correctly.
On ceramic glass models, the
oven control lockout is set.
Cookware is not the proper size.
Control knob set to incorrect heat
level
Range is not level.
Element cycling due to a
temperature limiter
Delay start is set.
Control lock is on.
Control is in Demo Mode.
Electronic oven control set
incorrectly
Oven temperature needs
adjustment.
Power to range is turned on or
restored.
Power failure (display shows
flashing time)
Error code (display shows letter
followed by number)
Start needs to be pressed so a
cycle can begin (display shows
"PUSH" or "PSH").
The oven door is not closed.
The Self-Cleaning function has
not been entered correctly.
A Timed Cooking function has
been entered.
The range is in Sabbath Mode.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
Push in knob before turning to a setting.
See the control lock keypad feature in the "Feature Guide."
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ¹⁄₂" (13 mm) outside the cooking area.
See "Cooktop Use" section.
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
See "Cook Time" section.
Press and hold START for 3 seconds to unlock.
Press and hold START TIME for 10 seconds to exit Demo
Mode. Demo Mode is used for display models in a showroom.
See "Electronic Oven Controls" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator lights keep flashing, call for service. See
cover for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Depending on your model, press CANCEL to clear the display.
See "Control Display" in the "Electronic Oven Controls"
section. If it reappears, call for service. See cover for contact
information.
See the "Start" keypad feature in the "Feature Guide" section.
Make sure the oven door is fully closed.
See the "Self-Cleaning Cycle" section.
See the "Cook Time" section.
See the "Sabbath Mode" section.