Table of Contents
Advertisement
Available languages
Available languages
SURFACE BURNERS
Sealed Burner models
See "Sealed Surface Burners" section.
Open Burner models
See "Surface Burners" section.
COOKTOP CONTROLS
Do not use steel wool, abrasive cleansers or oven cleaner.
Do not soak knobs.
When replacing knobs, make sure knobs are in the OFF position.
On some models, do not remove seals under knobs.
•
Soap and water or dishwasher:
Pull knobs straight away from control panel to remove.
CONTROL PANEL
Do not use abrasive cleaners, steel-wool pads, gritty wash cloths
or some paper towels. Damage may occur.
•
Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
OVEN CAVITY
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
On some models, the oven door can be removed. See "Oven
Door" first.
•
Steel wool pad
•
Oven cleaner:
Follow product label instructions.
Do not let cleaner contact
gasket, thermostat
or exterior surfaces. Line the floor with
newspaper.
OVEN AND ROASTING RACK
•
Steel wool pad
BROILER PAN AND GRID
Do not clean in the Self-Cleaning cycle.
•
Mildly abrasive cleanser:
Scrub with wet scouring pad.
•
Solution of 1/2cup (125 mL) ammonia to 1 gallon (3.75 L)
water:
Soak for 20 minutes, then scrub with scouring or steel wool
pad.
•
Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
•
Dishwasher
OVEN DOOR GLASS (on some models)
•
Glass cleaner and paper towels or non-abrasive plastic
scrubbing pad
The oven light is a standard 40-watt appliance bulb. This oven
does not have an automatic door light switch. Press the manual
oven light switch on the backguard to turn on and off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
1. Unplug range or disconnect
power.
2. Turn bulb counterclockwise
to remove from socket.
3. Replace bulb.
4. Plug in range or reconnect power.
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
To Remove:
1. Open the oven door. Insert hinge pins, included with your
range, into both hinge hangers. Do not remove the pins while
the door is removed from the range.
2. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
3. Pull door straight up, then toward you. Do not remove hinge
pins until the door is replaced on the range.
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
2. Hold oven door so that the top edge of each door slot is
horizontal. Insert door hinge into the hinge slots.
11
Advertisement
Table of Contents
