One-Time Auto-Arming Bypass; Low Battery Warning; Multiple Event Total Recall - Clifford Intelliguard 770 Owner's Manual

one-time auto-arming bypass

This will bypass the auto arm feature once only.
1. With the key, turn the ignition on, then off within two seconds.
2. The siren will chirp once to confirm auto arming bypass.
3. The system will not auto arm.
n n o o t t e e : : The system will revert to normal auto arming when the system
sees the ignition on for at least three seconds.
During auto arming bypass the system will not roll up the windows if
SmartWindows is connected, and the accessory output will not auto-
activate when using the remote to arm the system.

low battery warning

When the remote battery is low, the system will generate a low-pitched
tone when disarmed.

multiple event total recall

This will report the last eight system triggers.
1. Press and hold
2. While still holding
release the button.
3. The LED will start to blink to indicate the most recent trigger
and proceed down to the eighth trigger. If fewer than eight
triggers are stored in memory, the LED will blink continuous-
ly until the system is armed/disarmed using the remote or
14
of the PlainView 2 Valet
, arm and disarm the system, then
button.
®