Fisher & Paykel DE7060P2 Installation Manual/User Manual page 58

Completing the installation
Installation test cycle
Ensure the installation test cycle is completed before you dry any items in your dryer.
This is to check that your dryer is installed correctly and that it is functioning properly
prior to use.
Turn your dryer on by pressing the 'Power' button.
1
Select the 'Time Dry' cycle for 30 minutes. Ensure the drum is empty and the door is
2
closed (you will hear it click shut).
Touch the button. The drum will start rotating.
3
Observe the dryer for any problems.
z
The dryer will beep and display any faults on the screen if there are any problems. Refer
z
to page 28.
At the completion of the cycle open the door and check that there is warmth inside the
4
dryer. This indicates the dryer is operating normally.
If there are any problems, you must address these before proceeding with normal use.
The dryer will automatically turn off at the end of the cycle if there are no problems.
Before you start, it is a good idea to go through the following checklist:
Has the packaging been removed?
1
Is the lint filter correctly in place?
2
Has the power cord been connected to an appropriate power supply and the power
3
turned on?
Have you performed the installation test cycle?
4
14
INSTALLATION INSTRUCTIONS