Fisher & Paykel DE7060P2 Installation Manual/User Manual page 57

Before a rear venting option is installed the dryer must be changed from the
front venting factory setup. Remove the outlet grille from the front left-hand side
and replace with the outlet cover from the rear left-hand side. These covers should
be gently pried at the sides to prevent damage.
External venting options
The dryer can be vented with a kit that can
z
be positioned to vent upwards or to the side.
Kit part number PD-DK4W.
The dryer can be vented directly through the wall
z
with Kit part number PD-SVHCW4, in combination
with the duct adaptor supplied with the dryer.
Note: the vent system should be a maximum of 2 metres
with no more than three 90⁰ bends.
Internal venting
Front venting is the only option for internal venting.
The dryer is set up for front venting when it leaves
the factory.
Note: all efforts should be made to vent the dryer
externally, if possible, to avoid moisture build up in
the area around the dryer.
Electrical connection
This appliance must be connected to a 220V – 240V, 50Hz,
1
sinusoidal, 10A electrical supply.
Uncoil the power cord, remove and discard the plastic pin
2
cover and plug into a power socket.
Connect the appliance to an earthed outlet protected
3
by a fuse of suitable capacity.
Check the power cord for damage and make sure it is not
z
squashed or twisted when installing the dryer.
Always remove the power cord from the power socket by the plug, not by the cord.
z
INSTALLATION INSTRUCTIONS
Wall mounting ducting
Through-wall
mounted ducting
13