Fisher & Paykel DE7060P2 Installation Manual/User Manual page 35

PROBLEM
Linting
Fabric damage
TROUBLESHOOTING
POSSIBLE CAUSES
Lint filter not cleaned or
replaced.
Loads not sorted correctly.
Clothes over dried.
New items have been dried
in the dryer recently.
New towels or flannelette
sheets can leave lint in the
dryer, which may be picked
up by subsequent loads.
Catching on metal part on
items in the load.
Items not separated or dried
on an appropriate cycle for
the fabric type.
Items fell off the rack when
using 'Rack Dry'.
'Dry Temp' or 'Dryness
Level' selected not
appropriate for the fabric
type.
Used a 'Time Dry' cycle and
did not monitor the dryness
of clothes during the cycle.
Instructions on care label
not followed.
WHAT TO DO
Ensure the lint filter is cleaned after
every cycle and replaced correctly.
Refer to page 27.
Dry lint givers separately from
lint receivers. Dry similar colours
together eg light coloured items
with light coloured items, dark
items with dark items. Refer to page
19.
Over drying clothes in the dryer can
cause them to attract lint. Use an
auto sensing cycle or ensure you
check your load if using the time
dry cycles to avoid over drying.
Refer to pages 22 and 23.
Clean the lint filter and use 'Air Dry'
cycle to clear any remaining lint
from the dryer.
Fasten zips and other clasps before
placing items in the dryer.
Dry similar items together. Ensure an
appropriate cycle is selected. Refer
to pages 19, 22 and 23.
Ensure the rack is installed correctly
(refer to page 21) and only one
or two garments are placed on the
rack at a time.
Ensure the 'Dry Temp' and 'Dryness
Level' selected is appropriate for
the fabric type. Refer to the items
care label. Refer to pages 22 and
23.
Ensure that clothes are checked for
dryness during the cycle when using
the timed programmes to avoid
over drying. Refer to pages 22
and 23.
Follow the instructions on the care
label of the items.
31