Table of Contents
Advertisement
4. Mounting and Installation
4.1 Handling Precautions
This section provides handling precautions for use of the safety remote
I/O module.
DANGER
CAUTION
Do not touch the terminals while power is on.
Doing so could cause shock or erroneous operation.
Be sure there are no foreign substances such as sawdust
or wiring debris inside the module.
Such debris could cause fires, damage, or erroneous
operation.
Do not disassemble or modify the modules.
Doing so could cause trouble, erroneous operation, injury,
or fire.
If the product is repaired or remodeled by other than the
specified FA centers or us, the warranty is not covered.
Do not directly touch the module's conductive parts or
electronic components. Touching the conductive parts
could cause an operation failure or give damage to the
module.
Since the module case is made of resin, do not drop or
apply any strong impact to the module.
Doing so may damage the module.
Tighten a terminal block mounting screw, terminal screw,
and module mounting screw within the specified torque
range. If the terminal block mounting screw or terminal
screw is too loose, it may cause a short circuit, fire, or
malfunctions.
If too tight, it may damage the screw and/or the module,
resulting in a drop of the screw or module, a short circuit
or malfunctions.
If the module mounting screw is too loose, it may cause a
drop of the screw or module.
Over tightening the screw may cause a drop due to the
damage of the screw or module.
When disposing of this product, treat it as industrial
waste.
9
Advertisement
Table of Contents
