Advertisement
2.1 Applicable PLC
Series name
FX
series
2N
FX
series
2NC
FX
series
3U
FX
series
3UC
3. Installation
Caution
1) Do not lay signal cable near to high voltage power cable or house them in the same trunking
duct. Effects of noise or surge induction may occur. Keep signal cables a safe distance of more
than 100 mm (3.94") from these power cables.
2) Ground the shied wire or the shield of a shielded cable at one point on the PLC.
Do not, however, ground at the same point as high voltage lines.
3) Cut off all phases of power source before installing / removing or performing wiring work on the
unit in order to avoid electric shock or damage of product.
4) Replace the provided terminal cover before supplying power and operating the unit after
installation or wiring work, in order to avoid electric shock.
3.1 Mounting
The FX
-10PG can be DIN rail direct wall mounted.
2N
1) DIN rail mounting
a)
Align the upper side of the DIN rail mounting groove of the FX
DIN rail( ). See Figure 3.1.
b)
When removing the FX
removed ( ). See Figure 3.1.
*1 Uses DIN 46277 <35mm (1.38")>
Attach to DIN Rail and Remove from DIN Rai
2) Direct mounting to back walls
The FX
-10PG can be mounted with M4 screws, using the direct mounting holes.
2N
An interval space between each unit of 1-2 mm is necessary.
4. Specifications
4.1 General Specifications
General Specifications
Items
Items other than the
following
Dielectric with stand
voltage
All versions (First release).
All versions (First release).
All versions (First release).
All versions (First release).
-10PG from the DIN rail, the hook for DIN rail is pulled ( ), and the FX
2N
‚
Same as general specification of the PLC main unit.
(Refer to the PLC MANUAL)
AC 500V 1 minute (between each terminal and earth terminal)
Applicable version
-10PG with a DIN rail
2N
ƒ
Specifications
*1
( ), and push it on the
-10PG is
2N
„
Advertisement
