Connecting To The Mains; Connecting To Host; Charging; Cables - CAMBRIONIX SuperSync15 User Manual

Hide thumbs Also See for SuperSync15:

User manual (12 pages)

User manual (46 pages)

User manual (40 pages)

Table Of Contents

Table of Contents

Connect the Power Supply Unit (PSU) to the hub using the 4-pin DIN plug. Connect the power

cable to the PSU. Making sure you adhere to local safety regulations, connect the power cable

to the 100 – 250 VAC mains power outlet and switch the hub on using the small power switch

located adjacent to the power input connector on the hub. When the device is switched on, a

red LED next to the power input will be illuminated. The hub is now ready to charge attached

Periodic inspections should be made to power supply cables and any USB cables for any signs of

Once the power is connected, connect the SS15 to your host system using a USB 3.2 Gen 1

Type-A cable. Using an incorrect host cable may result in the hub and all subsequent ports not

Please note that USB specifications require a minimum 100 mA charge current to be delivered

during data transfer. As indicated in above, if the attached device has a BC1.2 compliant CDP

Your SS15 will allow your device to charge at the maximum rate possible up to 2.1A. The way

that charging takes place is the SS15 will provide the device with a capability to charge and the

devices USB charging controller will determine the maximum amount of charge it wants to

Some USB cables are data transfer only, and some are power delivery only. There are also

options that can handle both tasks. Be sure to verify a cable's abilities before purchasing it and

select a cable which can handle the speeds and power transfer that you require. We would

advice using the cable that was provided with the device to connect to our hubs

Page 9 of 38

damage. If any damage is found, replace the damaged cord before further use

port, the device can draw up to 2.1A while transferring data

200329

200337

200341