Table of Contents
Advertisement
MC-42S CONCRETE MIXER — RULES FOR SAFE OPERATION
■ NEVER run engine without air cleaner. Severe engine damage
may occur.
■ ALWAYS read, understand, and follow procedures in
Operator's Manual before attempting to operate equipment.
■ ALWAYS be sure the operator is familiar with proper safety
precautions and operations techniques before using roller.
■ ALWAYS store equipment properly when it is not being used.
Equipment should be stored in a clean, dry location out of the
reach of children.
■ NEVER leave the mixer unattended, turn off engine or electric
motor when unattended.
■ CAUTION must always be observed while servicing this mixer.
Rotating parts can cause injury if contacted.
■ Unauthorized equipment modifications will void all
warranties.
■ Ensure that any extension cable is protected against damage
and not liable to be tripped over or trapped underneath the
mixer.
■ DO NOT allow extension cord to come into contact with water
or fluids.
■ DO NOT spray water onto electric motor.
■ This mixer is intended for the production of concrete. Mixer
must be used only for its intended purpose.
■ This mixer is not suitable for the mixing of flammable or
explosive substances.
■ NEVER operate the mixer in an explosive atmosphere.
■ Before starting the mixer, check that all guards are in position
and correctly fitted.
■ Keep area around the mixer clear of obstructions which
could cause persons to fall onto moving parts .
■ ALWAYS ensure mixer is on level ground before mixing.
■ Become familiar with the controls of the mixer before
operating.
■ ALWAYS replace any worn or damaged warning decals.
■ Ensure the drum is rotating while filling and emptying the
drum.
■ ALWAYS disconnect AC power plug from power source
before moving mixer (electric model only).
■ High Temperatures – Always stop engine and allow the
engine to cool before adding fuel, oil or performing service
and maintenance functions. Contact with hot components
can cause serious burns.
PAGE 10 — MC-42S CONCRETE MIXERS — OPERATION AND PARTS MANUAL — REV. #9 (03/07/17)
■ NEVER disconnect any "emergency or safety devices" .
These devices are intended for operator safety. Disconnection
of these devices can cause severe injury, bodily harm or even
death! Disconnection of any of these devices will void all
warranties.
■ If mixer is equipped with an electric motor, operate electric
motor only at the specified voltage indicated on the nameplate.
■ Make sure the OFF/ON power switch on the electric motor is
always in the OFF position before inserting the mixer's power
plug into an AC receptacle (electric model only).
Maintenance Safety
■ NEVER lubricate components or attempt service on a running
machine.
■ ALWAYS allow the machine a proper amount of time to cool
before servicing.
■ Keep the machinery in proper running condition.
■ Fix damage to the machine immediately and always replace
broken parts, or missing decals.
■ Dispose of hazardous waste properly. Examples of potentially
hazardous waste are used motor oil, fuel and fuel filters.
■ DO NOT use food or plastic containers to dispose of
hazardous waste.
■ DO NOT pour waste, oil or fuel directly onto the ground,
down a drain or into any water source.
Emergencies
■ ALWAYS know the location of the nearest fire extinguisher
and first aid kit.
■ In emergencies always know the location of the
nearest phone or keep a phone on the job site .
Also know the phone numbers of the nearest
ambulance , doctor and fire department . This
information will be invaluable in the case of an
emergency.
Advertisement
Table of Contents
