Hilti Nuron TE 2-22 Original Operating Instructions page 39

2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery. → page 29
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Fitting the side handle
1. Release the side handle clamping band by turning the handle grip.
2. Slide the side handle clamping band over the chuck from the front and
into the recess provided.
3. Bring the side handle into the desired position.
4. Tighten the side handle clamping band by turning the handle grip.
5.5 Fitting and adjusting the depth gauge
1. Press and hold down the release button on the side handle.
2. Slide the depth gauge from the front into the opening provided in the
side handle. Adjust the depth gauge to the desired drilling depth.
3. Release the release button.
▶ The depth gauge is locked.
5.6 Fitting the accessory tool
Apply a little grease to the connection end of the accessory tool.
Use only the recommended grease supplied by Hilti. Using the wrong
grease can result in damage to the product.
1. Push the accessory tool into the chuck as far as it will go, turning it and
applying light pressure until it engages with an audible click.
2. After fitting the accessory tool, grip it and pull it in order to check that it
is securely engaged.
▶ The product is ready for use.
*2266024*
2
4
2266024
3
English 33