Rear Wheel - Yamaha TT-R230X 2007 Owner's Manual

3. Pull the wheel axle out, and then
remove the wheel.
Do not apply the brake after the Do not apply the brake after the Do not apply the brake after the Do not apply the brake after the Do not apply the brake after the
wheel has been removed together wheel has been removed together wheel has been removed together wheel has been removed together wheel has been removed together
with the brake disc, otherwise the with the brake disc, otherwise the with the brake disc, otherwise the with the brake disc, otherwise the with the brake disc, otherwise the
brake pads will be forced shut. brake pads will be forced shut. brake pads will be forced shut.
brake pads will be forced shut. brake pads will be forced shut.
T T T T T o install the front wheel o install the front wheel o install the front wheel o install the front wheel
o install the front wheel
1. Insert the wheel axle, and then
tighten it to the specified torque.
T T T T T ightening torque: ightening torque: ightening torque: ightening torque: ightening torque:
Wheel axle:
80 Nm (8.0 m.kgf, 58 ft.lbf)
2. While applying the front brake,
push down hard on the handlebars
several times to check if the front
fork compresses and rebounds
smoothly.
PERIODIC MAINTENANCE AND MINOR REPAIR PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP

Rear wheel

Rear wheel Rear wheel
Rear wheel Rear wheel
T T T T T o remove the rear wheel o remove the rear wheel o remove the rear wheel o remove the rear wheel o remove the rear wheel
It is advisable to have a Y It is advisable to have a Yamaha It is advisable to have a Y
l l l l l It is advisable to have a Y It is advisable to have a Y
dealer service the wheel. dealer service the wheel. dealer service the wheel.
dealer service the wheel. dealer service the wheel.
Securely Securely support support
Securely Securely Securely support support support
l l l l l
motorcycle so that there is no motorcycle so that there is no motorcycle so that there is no motorcycle so that there is no motorcycle so that there is no
danger of it falling over danger of it falling over danger of it falling over. . . . . danger of it falling over danger of it falling over
1. Remove the brake adjuster.
2. Remove the brake rod from the
brake cam lever
3. Loosen the axle nut
1. Adjuster
2. Brake rod
3. Brake cam lever
4. Axle nut
6-29
4. Lift the rear wheel off the ground
according to the procedure on
page 6-28.
5. Remove the axle nut.
amaha amaha amaha
amaha
6. Push the wheel forward, and then
remove the drive chain from the
the the
the the the
rear sprocket.
The drive chain does not need to be
disassembled in order to remove and
install the wheel.
7. Remove the wheel.
AIR AIR AIR AIR
6 6 6 6 6