Cleaning The Spark Arrester - Yamaha TT-R230X 2007 Owner's Manual

Cleaning the spark arrester

Cleaning the spark arrester Cleaning the spark arrester
Cleaning the spark arrester Cleaning the spark arrester
Make sure to select a well-ventilated
area free of combustible materials to
clean the spark arrester.
1. Remove the tailpipe by removing
the bolts, and then pulling it out of
the muffler.
1
(×3)
1. Bolt
2. Tap the tailpipe lightly, and then use
a wire brush to remove any carbon
deposits from the spark arrester
portion of the tailpipe.
PERIODIC MAINTENANCE AND MINOR REPAIR PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP PERIODIC MAINTENANCE AND MINOR REP
1 2
1. Tailpipe
2. Spark arrester
3. Insert the tailpipe into the muffler,
and then install and tighten the
bolts.
Make sure to align the bolt holes when
inserting the tailpipe.
4. Remove the purging bolt.
6-13
1. Purging bolt
5. Start the engine and rev it
approximately twenty times while
momentarily creating exhaust
system back pressure using a shop
towel to block the end of the
muffler.
6. Stop the engine and allow the
exhaust pipe to cool.
7. Install the purging bolt and tighten
it.
AIR AIR AIR AIR
6 6 6 6 6