Kyocera QCP 1960 User Manual page 39

prevents you from making or receiving calls outside your home
No Roaming
service area.
The QCP 860 Thin Phone has two other options,
two cellular blocks. By selecting one block, you prevent your phone from operating
on the other block.
sets your Number Assignment Module (NAM) correctly for your current
8 2 Set NAM
area if you have phone accounts with multiple service providers. For instance, if you
travel frequently between two cities, you might have a phone account set up in each
city. When you are in City A, use this menu item to change to your City A account. If
you do not have a NAM in City A, then all your phone calls would be roaming calls
and would incur higher charges.
allows the phone to switch to one of the programmed NAMs when it
8 3 Auto NAM
detects the appropriate network signal. Leave the setting at "off" unless you have
accounts with more than one service provider.
determines whether the phone can receive both voice and data calls, or just
8 4 Data/Fax
data calls.
The setting allows both if your phone network can distinguish between voice
off
and data.
Fax for next call
Data for next call
automatically reset to off after a fax or data call is received or after 10 minutes if a
call is not received in that time.
Fax until power OFF
Data until power OFF
settings remain until you reset the menu to off or turn off the phone.
(on QCP 860 Thin Phones only) forces the phone into analog mode until
8 5 Force Call
the end of the next incoming or outgoing call, or for the next ten minutes.
-or-
(on QCP 2760 Thin Phones only) sets the phone to operate in digital mode,
8 5 Digital
analog mode, or both.
34
forces the next call into fax mode.
forces the next call into data mode. The "next call" modes
forces the phone into fax mode.
forces the phone into data mode. The "until power off"
and
A Side B Side.
They refer to the
Menus