Mercedes-Benz E-CLASS 2009 Manual page 215

mkalafa,
Features
212
i
The garage door opener is only available
for certain countries. Observe the legal
requirements in all countries concerned.
The HomeLink
compatible with most European garage and
gate opener drives. More information on
®
HomeLink and/or compatible products is
available from:
any Mercedes-Benz Service Centre
R
R the HomeLink
(0) 08000 466 354 65 (free of charge) or
+49 (0) 6838 907-277 (charges apply)
the Internet: www.homelink.com
R
G
Risk of accident
Only press the transmitter button on the inte-
grated remote control if there are no persons
or objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Programming the remote control
i
You will achieve the best results by insert-
ing new batteries in the garage door's
remote control before programming it.
Erase the memory of the integrated remote
X
control ( page 213) before programming
Y
it for the first time.
Turn the key to position 2 in the ignition
X
lock.
®
garage door opener is
®
hotline
Version: 2.11.8.1
Press and hold one of transmitter but-
X
tons ; to ? on the integrated remote
control.
Indicator lamp : starts to flash after a
short while. It flashes about once a second.
i
Indicator lamp : flashes immediately
the first time the transmitter button is pro-
grammed. If this transmitter button has
already been programmed, indicator
lamp : will only start flashing at a rate of
once a second after 20 seconds have
elapsed.
Keep the transmitter buttons depressed.
X
Point the garage door's remote control with
X
the transmitter towards the left-hand side
of the rear-view mirror from a distance of 5
to 20 cm.
i
The distance between the garage door's
remote control and the integrated garage
door opener depends on the system of the
garage door drive. You might require sev-
eral attempts. You should test every posi-
tion for at least 20 seconds before trying
another position.
Keep the transmitter button on the garage
X
door's remote control depressed until indi-
cator lamp : starts to flash rapidly.
The programming was successful if indica-
tor lamp : flashes rapidly.
Release the transmitter buttons on the
X
garage door's remote control and the inte-
grated remote control.
If indicator lamp : goes out after approx-
imately 20 seconds and did not flash rapidly
before this:
Release the transmitter buttons on the
X
integrated and portable remote controls.
Repeat the programming procedure. When
X
doing so, change the distance between the
garage door's remote control and the trans-
mitter buttons in the rear-view mirror.
i
If the garage door system works with a
rolling code, after programming you must