SRAM G2 RE Service Manual page 20

6 Tighten each caliper body bolt until the caliper body halves contact. Tighten each caliper body bolt until the caliper body halves contact.
7
Orient the banjo to the original position. Orient the banjo to the original position.
8 Tighten each caliper body bolt to 8.5-10.1 N·m (75-90 in-lb). Tighten each caliper body bolt to 8.5-10.1 N·m (75-90 in-lb).
9 Cut the hose to install a new barb and compression fitting. Cut the hose to install a new barb and compression fitting.
All SRAM brakes that use a compression fitting and hose barb
must use a new SJ (Stealth-a-majig) hose barb and a new, red SJ
compression fitting upon reassembly.
The factory may have installed a non-red SJ compression
fitting, which functioned properly prior to disconnection. Upon
reconnection, you must install a new SJ hose barb and a new, red SJ
compression fitting.
Brake hoses assembled with non-Stealth-a-majig hose barbs and
compression fittings, will not function.
⚠ WARNI NG
5 mm
5 mm 8.5-10.1 N·m (75-90 in-lb)
SRAM Hydraulic Hose Cutter
5 mm
5 mm 8.5-10.1 N·m (75-90 in-lb)
20
Caliper Piston Installation