Omron ZEN Quick Manual page 32

7 Programming Functions
7.6.2. Settings in the Parameter Settings Screen
•
Comparison of holding and constant
timers (When the holding timer #0 ≥
12 min 34 s)
Comparator
address
Comparison type
Comparison data
Operator
Monitoring
enabled/disabled
7.6.3. Parameter Monitoring in the 'Screen Display'
•
Comparison of holding timer #0 and the
constant (When #0 ≥ 12 min 34)
Analog input 1 (I4) present value
OMRON ELECTRONICS, S.A.
Comparison type
Comparison data 1
Monitoring
enabled/disabled
Operator
Comparison
Data 2
T: Timer
#: Holding timer
C: Counter
1 T: T0 toT7
#: #0 to #3
C: C0 to C7
2 T: T0 to T7
#: #0 to #3
C: C0 to C7
Constant: 00.00 to 99.99 when the
comparison type is T / #.
0000 to 9999 when the comparison type
is C
≥: The corresponding timer/counter bit switches to ON mode when
data1≥data2
≤: The corresponding timer/counter bit switches to ON mode when
data1≤data2
A The parameters can be modified and monitored
D The parameters cannot be modified or monitored
Note. To enter the data as constant, press ALT.
Corresponding
bit status
(m:OFF / l:ON)
ZEN Programmable Logic Module
•
Comparison of counters (When counter
1 (C1) ≤ counter 2 (C2)
Comparator
address
Comparison possible between T
and T or T and the constant
Comparison possible between #
and # or # and the constant
Comparison possible between C
and C or C and the constant
•
Comparison of counters (When
counter 1 (C1) ≤ counter 2 (C2)
Analog input 1 (I4) present value
Analog input 2 (I5) present value
Comparison type
Comparison data 1
Monitoring
enabled/disabled
Operator
Comparison
Data 2
Corresponding
bit status
(m:OFF / l:ON)
Page 32