Power Mode; Trigger Mode - SATO ARGOX AS-9400 User Manual

AS-9400
User Guide

Power Mode

Parameter # 0x80
This parameter determines the power mode of the engine.
In Low Power mode, the scan engine enters into a low power consumption Sleep power state
whenever possible (provided all WAKEUP commands were released).
In Continuous Power mode, the scan engine remains in the Awake state after each decode attempt (see
Power Management).
The Sleep and Awake commands (see
either the Low Power mode or the Continuous Power mode.

Trigger Mode

Parameter # 0x8A
（Level）Key Holding
Press the button to trigger the reading, release the button to end the reading. Reading success or reading
time over a single reading time will end the reading.
（Pulse）Single Key Trigger
Detects the change of the key level (Maintain 30ms, depending on the product )to start reading, and then
detects the change of the key level (Maintain 30ms, depending on the product )again to end reading. Reading
success or reading time over a single reading time will end the reading.
M
Continuous ode
The reading engine performs continuous work. Reading success or reading time over a single reading
time will end the reading. More than the specified time will automatically trigger the next reading.
I
Automatic nduction
In automatic induction mode,the scan engine detects the brightness of the surroundings. Trigger reading
when the brightness changes. Reading success or reading time over a single reading time will end the reading.
Regardless of the last success or failure to read, re-enter the detection of the surrounding environment
brightness.
Host
Through the command to trigger the scan engine to read, also through the command to trigger the scan
engine to end reading. Reading success or reading time over a single reading time will end the reading.
Note: Key Trigger(Level and Pulse) still valid in other modes
SLEEP
Continuous Power
M
ode
SeePower Management .
and WAKEUP) can be used to change the power state in
(0x00)
Low Power
(0x01)
3