www.seagate.com
2.7
Power specifications
The drive receives DC power (+5V or +12V) through a native SATA power connector. Refer to
2.7.1 Power consumption
Power requirements for the drives are listed in
of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature. These power
measurements are done with DIPM enabled.
• Spinup current is measured from the time of power-on to the time that the drive spindle reaches operating
speed.
• Operating Power is measured following IDEMA 3 streams standard, assuming CE operating condition
• The drive supports three idle modes: Performance Idle mode, Active Idle mode and Low Power Idle mode.
Refer to Section 2.7.4 for power-management mode.
Table 3
DC power requirements (8TB & 6TB)
Power dissipation
Spinup
Idle, Low Power
Operating Power
Standby
Sleep
Table 4
DC power requirements (4TB - 1TB)
Power dissipation
Spinup
Idle, Low Power
Operating Power
Standby
Sleep
Seagate SkyHawk Product Manual, Rev. C
and
Table 3
Avg (watts 25° C)
Avg 5V typ amps
—
3.4
5.0
0.25
0.25
Avg (watts 25° C)
Avg 5V typ amps
—
2.5
3.5
0.25
0.25
. Typical power measurements are based on an average
Table 4
Avg 12V typ amps
—
1.8
0.10
0.242
0.23
0.321
0.04
0.004
0.04
0.004
Avg 12V typ amps
—
1.8 (4TB - 3TB)
1.1 (2TB - 1TB)
0.12
0.15
0.24
0.191
0.04
0.004
0.04
0.004
Drive Specifications
Figure 1 on page 22
.
14