Supported Interfaces; Video; Power Supplies - Compaq ProLiant 6000 Series Setup And Installation Manual

Supported Interfaces

Wide-Ultra SCSI-3 (Very High Density Connector Interface connector)
Serial (two connectors)

Video

Parallel
Keyboard
Mouse
Dual-port 10/100TX UTP Ethernet (two RJ-45 connectors)
Video
Integrated PCI Video Controller provides maximum resolution of 1024 x 768
non-interlaced resolution with 2 MB memory
From 16 to more than 256 colors, depending on graphics mode
Supports SVGA, VGA, and EGA graphics resolution

Power Supplies

Supports up to three hot-plug, redundant power supplies.
IMPORTANT: Hot-plug power supplies are not designed to be installed
with AC current connected. Be sure to disconnect from AC current prior to
removal or installation of hot-plug power supplies.
Power supplies are load-balancing and have microcontroller monitoring
for advanced health and configuration management.
Supports up to three power supplies. Depending upon the system load
configuration, more than one power supply may be required to power the
system. See Table 1-1, "Power Supply Support Provided for System
Configurations," to determine power supply requirements.
Additional security is provided with a power supply security bar and a
padlock.
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
Compaq ProLiant 6000 Setup and Installation Guide
1-5