Compaq ProLiant 6000 Series Setup And Installation Manual page 64

2-36 Server Installation and Start Up
1. Slide the Power On/Standby switch cover plate to the right.
pat-28.eps
Figure 2-26.
2. Press the Power On/Standby switch to STANDBY. This places the
server in standby, thereby disabling the main power supply output and
providing auxiliary power (+ 5V) to the server. Standby does not disable
main output power.
3. Verify the system LED on the front panel, near the power on/standby
switch, is off and fan noise abates.
4. Disconnect all power cords from the server to disable all power to the
server.
2
Turning off power to the server
For use with Pentium II Xeon and Pentium III Xeon processor-based servers only
1