Install The Software; Windows 95/98/98Se/2000/Nt4.0 - Minolta DIMAGE SCAN MULTI II F-3100 Instruction Manual

INSTALL THE SOFTWARE

To use the Dimage Scan Multi II, install the software by following the procedure below.
CAUTION – Before installing
• Make sure that the Damage Scan Multi II is connected to your PC correctly. For connecting the
Dimage Scan Multi II to the PC, refer to the hardware instruction manual.
• The antivirus system extensions may conflict with the operation of this installer. Remove or
disable any extensions before launching this installer and replace or re-enable them when
installations are complete.

WINDOWS 95/98/98SE/2000/NT4.0

These installation instructions assume drive C or D is the CD-ROM drive or the startup disk drive
respectively.
1 Turn on the Dimâge Scan Multi II.
2 Turn on the PC and start up Windows.
• The"[New Hardware Found" window will appear.
FOR WINDOWS 2000/NT4.0
3 Select "Do not install a driver." and
click on [OK].
• This dialog box may appear several times.
Repeat step 3 until the dialog box no longer
appears.
FOR WINDOWS 95 RELEASE 2 (OSR2)
• The 2 dialog boxes shown on the left will
appear.
3a Click on [Next >] in the first dialog
box.
Click on [Finish] in the second dialog
3b
box.
FOR WINDOWS 98
3
Click on [Next >] until [Finish]
appears and Click on [Finish] at last.
4 Insert the Dimâge Scan Multi II CD-
ROM into the CD-ROM drive.
– 9 –