Table of Contents
Advertisement
INSTALLING THE SOFTWARE (Windows
Follow the procedure below to install the software on your Windows PC.
RAM stationed programs such as anti-virus programs or installation monitoring programs
may cause the installer to fail. Uninstall those programs from your system or temporarily
disable them before starting the installation, and then put them back on your system after
completing the installation.
For Windows
®
:
* In the procedure below, the hard disk drive for system startup is assumed as "drive C", and the CD-ROM
drive as "drive D".
• You should install the software on the Windows
1. Turn on your PC to start Windows
2. Insert the attached "DiMAGE Software CD-ROM" into the CD-ROM drive.
®
2000/NT4.0 PC with the Administrator privilege.
®
.
After a short time, the "DiMAGE Installer Menu"
window (figure-left) appears.
3. Click the "Starting up the DiMAGE
Image Viewer Utility installer" button.
The "InstallShield Wizard" program starts
automatically, and the "Welcome" window appears.
See the digital camera's instruction manual for
details of the "Starting up the USB device driver
installer" (this button is active if you use
Windows
®
98/98 Second Edition) or the "Starting up
the QuickTime installer" button.
- 10 -
®
)
Advertisement
Table of Contents
