Icom IC-T10 Advanced Manual page 31

5
SET MODE
Initial Set Mode items
Voltage indication
Selects whether or not to display the battery voltage
while turning ON the transceiver.
• OFF: The transceiver does not display the
battery voltage.
• On: The transceiver displays the battery
voltage.
Auto low power
Selects whether or not to enable the Auto Low Power
function.
• OFF: Turns OFF the function.
• On: When the temperature goes
below 0˚C (32˚F), the transceiver
automatically sets the all output
power to low.
L High or Mid power are disabled.
Tone burst
Selects whether or not to enable the Tone Burst
function when using the Tone Squelch function.
• OFF: When you transmit a signal that
superimposes the CTCSS tone, the
other stations may hear a short burst
of noise from their receiver, just after
you stop transmitting.
• On: When you transmit a signal that
superimposes the CTCSS tone, the
function mutes the noise from being
heard in the other station receiver.
(Default: On) Earphone antenna
Selects whether or not to use the earphone antenna
for FM radio.
• OFF:
• On:
Monitor
(Default: OFF)
Selects how to use the Monitor function.
• PUSH:
• HOLd:
(Default: OFF)
5-9
An earphone antenna is not used.
An earphone antenna is used.
(Default: PUSH)
Hold down [MONI] to monitor
the frequency. Release to stop
monitoring.
Push [MONI] momentarily to monitor
the frequency and push momentarily
again to cancel it.
(Default: OFF)