Envelope - Konica Minolta Magicolor 2480 MF User Manual

DO NOT use card stock that is
Mixed with any other media in the trays (as this will cause media misfeed-
ing)

Envelope

Print on the front (address) side only. Some parts of the envelope consist of
three layers of paper—the front, back, and flap. Anything printed in these lay-
ered regions may be lost or faded.
You can print continuously with envelope. However, this could affect the
media feed, depending on the media quality and printing environment. If
problems occur, stop the continuous printing and print one sheet at a time.
Capacity
Driver
Media Type
Duplexing
43 lb bond is also referred to as 90 lb index stock.
Use envelopes that are
Common office envelopes approved for laser printing with diagonal joints,
sharp folds and edges, and ordinary gummed flaps
Approved for laser printing
Dry
DO NOT use envelopes that have
Sticky flaps
Tape seals, metal clasps, paper clips, fasteners, or peel-off strips for seal-
ing
Transparent windows
Too rough of a surface
Material that will melt, vaporize, offset, discolor, or emit dangerous fumes
Been presealed
Print Media
Tray 1
Tray 2
Envelope
Not supported
Because the envelopes pass through heated rollers, the gummed
area on the flaps may seal. Using envelopes with emulsion-based
glue avoids this problem.
Up to 10 sheets, depending on their thick-
ness
Not supported
27