Memory Dialing; Receiver Volume Control; Tone Control; Call Duration Display - ClearSounds CSC48 User Manual

Receiver volume control

The receiver volume control allows you to adjust the volume on the
handset, roll the Receiver Volume Control wheel located under the
handset to find a comfortable level (1-9).

Tone control

If the volume has been boosted up, you can also adjust the tone
control. You can adjust and increase the low frequency or high
frequency sounds to suit your hearing needs by sliding the ToNE
control located on the right side of the CSC48.
NOTE: The tone control will not function when the receiver volume
has been set to minimum level (boost LED is off).
Ringer
The ringer volume level can be adjusted by sliding the switch on the
right side of the unit to select oFF LoW HI.
Redial
The last number dialed is stored automatically, simple lift the handset
and press the redial button, the stored number will now be dialed.

Call Duration Display

After dialing the phone number, the current call duration, in minutes
and seconds, will be shown in the display (after a few seconds). You
can also use the internal clock as a stop watch, to use this feature
press the TIMER button while you are on a call or with the receiver
on the hook. The time measurement can be stopped by using the
same button TIMER. The measured time will be shown in the display
for a few seconds then return to showing the current time.

MEMORY DIALING

This telephone has 3 one-Touch memory buttons numbered M1-M3.
once a number has been stored in a memory location, you only need
to press one button to make the call.
Storing One-touch Memory Buttons
1 Lift the handset.
2 press the STORE button.
3 Enter the telephone number to be stored, maximum 16 digits.
4 press the STORE button again.
5 press M1-M3 to store the number.
6 – ENGLISH