Processor And Fan Option - HP BCDVideo BCD108 User Manual

Install high-performance fans in each of the 7 fan bays.
7.
8.
Install the access panel (on page 22).
9.
Slide the server into the rack.
10.
Connect each power cord to the server.
11.
Connect each power cord to the power source.
12.
Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED
changes from amber to green.

Processor and fan option

The server supports single-processor and dual-processor operations.
CAUTION: To avoid damage to the processor and system board, only authorized personnel
should attempt to replace or install the processor in this server.
CAUTION: To prevent possible server malfunction and damage to the equipment,
multiprocessor configurations must contain processors with the same part number.
IMPORTANT: If installing a processor with a faster speed, update the system ROM before
installing the processor.
To install the processor:
1.
Power down the server (on page 21).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 21).
o
Remove the server from the rack (on page 22).
4.
Remove the access panel (on page 22).
5.
Remove the processor blank.
Hardware options installation 35