PAC RB10GM14B Manual page 5

Stinger heigh10 radio replacement kit for select 2014-2019 silverado/sierra truck

RB10GM14B

Section 1: Disassembly (cont.)

Part Three: Glove Box Removal (Optional)

If the vehicle is equipped with IO4, IO5 or IO6 radio AND a factory rear camera, follow the steps below to

remove the glove box. For IO3 and IOB vehicles, or no factory rear camera, proceed to Part Four.

Step 1

Remove the two Torx T15 screws

from the bottom edge of the lower

glove box.

Step 4

Remove the two Torx T15 screws

and pull to remove the upper

glove box. Unplug the factory USB

port from the backside.

Pacific Accessory Corporation

Step 2

Open the upper and lower glove

box doors and remove the two

Torx T15 screws securing the

lower glove box.

Step 5

Up, behind the metal bar running

across the inner dash, locate the

HMI Module; black module with

multiple colored plugs facing down.

Stinger HEIGH10 Radio Replacement Kit

for select 2014-2019 Silverado/Sierra Truck

Step 3

Pull outward on the lower glove

box to release the retaining clips

and remove the lower glove box.

Step 6

Unplug the gray 12 pin camera

harness from the HMI module.

Rev: V1

Date: 030121

Page 5

Table of Contents