Introduction & Features
The RP4-NI11 interface allows the replacement of a factory radio in select Nissan vehicles with MSCAN databus radios.
Using this interface will retain factory features such as steering wheel controls (SWC), reverse camera and the factory
amplifier when the original radio is removed. Use of this interface also allows you to program two radio functions to each
SWC button by using short press long press dual command functionality. The RP4-NI11 also provides outputs such as
vehicle speed sensor (VSS), illumination and *reverse trigger.
Important Notes
1. The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
2. The interface comes pre-programmed for all of the vehicles factory SWC functions and does not require programming unless
you wish to re-assign the SWC functions or utilize short press long press dual command functionality. The SWC can always
be restored to default settings by pressing and releasing the program button on the side of the interface once and waiting 7
seconds for the LED to flash 4 times.
3. Does not retain 360 camera system
4. In some 2014+ Nissan Rogues, it may be necessary to find an alternate accesory 12v+ wire If the interface and aftermarket
radio are not powering up. Please see Appendix A on page 4 to find an alternate accessory 12v+ wire.
Wiring Connection Chart
Yellow
Battery +12v
Black
Ground
Red
Accessory 12v+
Purple / White
Vehicle Speed
Blue / White
Amp Turn On Input
Orange / White
Illumination Output
Green
*Reverse Output (+)
* Only available in vehicles
equipped with a factory reverse
camera.
Illustration / Schematic
Wiring
Cut for Non-Bose systems
Aftermarket Radio Connections
See above chart for wire color
description.
Pacific Accessory Corporation
Vehicle Connector
White
White / Black
Grey
Grey / Black
Output
Green
Green / Black
Purple
(+)
Purple / Black
Yellow RCA
Pacific Accessory Corporation
©2016 Pacific Accessory Corporation
Radio Replacement & Steering Wheel Control Interface
Front L + input
Front L - input
Front R + input
Front R - input
Rear L + input
Rear L - input
Rear R + input
Rear R - input
*Reverse Camera
Output
Programming
Button
| Ph. 866-931-8021 | support@pac-audio.com
®
www.pac-audio.com
for Nissan Vehicles
SWC Connector
Blu/Yel
3.5mm Jack
x4
SWC Connection
SWC Connection
Acc On/
Programming
LED
RP4-NI11
Kenwwod, Newer
JVC
Alpine, JVC,
Clarion, Fusion,
Pioneer, Sony,
Boyo, Dual,
Lightning Audio,
Visteon or Advent
See above chart for
different radio type
connections
Rev. 011116