PAC RP4-NI13 Quick Start Manual

RP4-NI13
Introduction and Features
The RP4-NI13 interface allows the replacement of a factory radio in select Nissan vehicles with MSCAN databus radios.
Using this interface will retain factory features, such as steering wheel controls (SWC), reverse camera, and the factory
amplifier, when the original radio is removed. Use of this interface also allows you to program two radio functions to
each SWC button by using short press, long press dual command functionality. The RP4-NI13 also provides outputs
such as vehicle speed sensor (VSS), illumination and *reverse trigger.
Important Notes
1. These instructions apply to R.1.5.1.4 or later revisions. The revision info can be found on a small white sticker on the interface
and packaging.
2. The radio select rotary switch on the side of the interface, must be adjusted to the proper radio setting before plugging the
interface into the vehicle (see next page for setting chart).
3. The interface comes pre-programmed for all of the vehicle's factory SWC functions, and does not require programming unless
you wish to re-assign the SWC functions, or utilize short press, long press dual command functionality. The SWC can always
be restored to default settings by pressing and releasing the program button on the side of the interface once, and waiting 7
seconds for the LED to flash 4 times.
4. Does not retain 360 camera system.
Wiring Connection Chart
Yellow Battery +12v
Black
Red Accessory 12v+
Pink Vehicle Speed
Blue / White Amp Turn On Input
Orange / White Illumination Output
Purple / White *Reverse Output (+)
* Only available in vehicles equipped with a factory reverse camera.
Illustration / Schematic
Wiring
Cut for Non-Bose systems
Aftermarket Radio Connections
See above chart for wire color
description.
Pacific Accessory Corporation
Vehicle Connector
White
Ground White / Black
Gray
(10 amp)
Gray / Black
Green
Output
Green / Black
Purple
Purple / Black
(+)
Yellow RCA
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Radio Replacement and Steering Wheel Control
Front L + input
Front L - input
Front R + input
Front R - input
Rear L + input
Rear L - input
Rear R + input
Rear R - input
*Reverse Camera
Output
x4
Programming
Button
PAC-audio.com
Interface for Select Nissan Vehicles
SWC Connector
Blu/Yel Kenwood, Newer
3.5mm Jack
Clarion, Fusion,
Pioneer, Sony,
Lightning Audio,
Visteon or Advent
SWC Connection
SWC Connection
Acc On/
Programming
LED
Rev: 1
Date: 9/14/2022
JVC
Alpine, JVC,
Boyo, Dual,
See above chart for
different radio type
connections
Page 1