Kohler LH630-775 Service Manual page 122

Remove Stator Assembly
1. Remove the two mounting screws, and pull the
stator, with the plug-in connector attached, from
the engine. See Figure 9-40.
Figure 9-40. Removing Stator Screws.
Remove Intake Manifold, Thermostat
Housing, By-pass Hose and Wiring
Harness
1. Disconnect the by-pass hose from the fitting on
the water pump. See Figure 9-41.
Figure 9-41. Removing By-pass Hose from Water
Pump Fitting.
2. Remove the six mounting screws and carefully
separate the intake manifold from the cylinder
heads, with the by-pass hose and wiring harness
attached. See Figures 9-42 and 9-43.
Figure 9-42. Removing the Six Intake Manifold
Screws.
Figure 9-43. Removing the Intake Manifold
Assembly from the Engine.
3. Remove the intake manifold gaskets.
Section 9
Disassembly
9
9.11