Table of Contents
Advertisement
•
Flexible conduit clamp
•
Cover plate
Using Designer's Optimize Workflow
Designer's Optimize workflow speeds up the process of connecting systems with at least 1 microphone and 1 audio processor.
Optimize also creates mute control routes in rooms with MXA network mute buttons. When you select Optimize in a room, De-
signer does the following:
•
Creates audio routes and mute control routes
•
Adjusts audio settings
•
Turns on mute synchronization
•
Enables LED logic control for applicable devices
The settings are optimized for your particular combination of devices. You can customize settings further, but the Optimize
workflow gives you a good starting point.
After optimizing a room, you should check and adjust settings to fit your needs. These steps may include:
•
Deleting unnecessary routes.
•
Checking levels and adjusting gain.
•
Verifying that AEC reference signals are correctly routed.
•
Fine-tuning DSP blocks as needed.
Compatible devices:
•
MXA910
•
MXA920
•
MXA710
•
MXA310
•
P300
®
•
IntelliMix Room
•
ANIUSB-MATRIX
•
MXN5-C
•
MXA Network Mute Button
To use the Optimize workflow:
1.
Place all relevant devices in a room.
2.
Select Optimize. Designer optimizes microphone and DSP settings for your equipment combination.
If you remove or add devices, select Optimize again.
Installing the Ceiling Loudspeaker
For ceiling tile installations, use the tile bridge accessory to support the weight of the loudspeaker. You can install the loud-
speaker in other types of ceilings if the material safely supports the weight of the loudspeaker.
To install, you will need:
•
Utility knife or other tool to cut hole in ceiling
•
Shielded Cat5e (or better) Ethernet cable
Shure Incorporated
5/26
Advertisement
Table of Contents
