ECS P6VPA2T Manual page 35

USB2/USB3: Front panel USB headers
The mainboard has two USB ports installed on the rear edge
I/O port array. Some computer cases have a special module
that mounts USB ports at the front of the case. If you have this
kind of case, use auxiliary USB connectors USB2 and USB3
to connect the front-mounted ports to the mainboard.
Pin Signal Name
1 VREG_FP_USBPWR0
3 USB_FP_P0-
5 USB_FP_P0+
7 Ground
9 Key
WOL1/WOM: Wake On LAN/Wake On Modem
If you have installed a LAN card, use the cable provided with
the card to plug into the mainboard WOL1 connector. This en-
ables the Wake On LAN (WOL) feature. When your system is
in a power-saving mode, any LAN signal automatically r e-
sumes the system. You must enable this item using the Power
Management page of the Setup Utility.
Pin Signal Name
1 5VSB
2 Ground
3 SENSE
If you have installed a modem, use the cable provided with
the modem to plug into the mainboard WOM1 connector. This
enables the Wake On Modem (WOM) feature. When your sys-
tem is in a power-saving mode, any modem signal
automatically resumes the system. You must enable this item
using the Power Management page of the Setup Utility. See
Chapter 3 for more information.
Pin Signal Name
2 VREG_FP_USBPWR0
4 USB_FP_P1-
6 USB_FP_P1+
8 Ground
10 USB_FP-OC0
29