Table of Contents
Advertisement
5 Unit installation
(a)
A safety device might stop the operation of the system if the unit
runs outside its operation range.
(b)
Condensation and water dripping might occur if the unit runs
outside its operation range.
5
Unit installation
5.1
Preparing the installation site
WARNING
Make sure installation, servicing, maintenance and repair
comply with instructions from Daikin and with applicable
legislation (for example national gas regulation) and are
executed only by authorised persons.
WARNING
The appliance shall be stored so as to prevent mechanical
damage and in a well-ventilated room without continuously
operating ignition sources (example: open flames, an
operating gas appliance or an operating electric heater).
5.1.1
Installation site requirements of the
indoor unit
INFORMATION
The sound pressure level is less than 70 dBA.
▪ Air flow. Make sure nothing blocks the air flow.
▪ Drainage. Make sure condensation water can be evacuated
properly.
▪ Wall insulation. When conditions in the wall exceed 30°C and a
relative humidity of 80%, or when fresh air is inducted into the
wall, then additional insulation is required (minimum 10 mm
thickness, polyethylene foam).
▪ Wall strength. Check whether the wall or the floor is strong
enough to support the weight of the unit. If there is a risk, reinforce
the wall or the floor before installing the unit.
▪ Spacing. Install the unit at least 1.8 m from the floor and keep the
following requirements in mind for distances from the walls and
the ceiling:
≥50
5.2
Opening the indoor unit
5.2.1
To remove the front panel
1 Hold the front panel by the panel tabs on both sides and open
it.
a
Panel tabs
Installation manual
6
2 Remove the front panel by sliding it to the left or the right and
3 Disconnect the front panel shaft on the other side in the same
a
5.2.2
1 Attach the front panel. Align the shafts with the slots and push
2 Close the front panel slowly; press at both sides and at the
5.2.3
1 Remove the front panel to remove the air filter.
2 Remove 2 screws from the front grille.
3 Push down the 3 upper hooks marked with a symbol with 3
a
≥50
4 We recommend opening the flap before removing the front
(mm)
5 Place both hands under the centre of the front grille, push it up
a
5.2.4
1 Install the front grille and firmly engage the 3 upper hooks.
pulling it toward you.
Result: The front panel shaft on 1 side will be disconnected.
manner.
a
Front panel shaft
To re-install the front panel
them all the way in.
centre.
To remove the front grille
CAUTION
Wear adequate personal protective equipment (protective
gloves, safety glasses,...) when installing, maintaining or
servicing the system.
circles.
b
a
Upper hook
b
Symbol with 3 circles
grille.
and then toward you.
To re-install the front grille
a
CTXF20~35C5V1B
Daikin room air conditioners
3P519299-13V – 2020.08
Advertisement
Table of Contents
