Mitsubishi 4DQ3 Service Manual page 29

(d) Install sleeve onto the rear end of crankshaft.
Apply clean engine oil to the internal surface of oil
seal {I) and secure it with bolts (2) by using oil seal
aligner,
( e) Apply Atom jet at the tip of bolts (3) as they fit into
four through-bolt holes in the bearing cap. Tighten
the bolts to a torque of 0.4 kgm (2.9 lb.ft).
(8) Install the front plate as follows:
(a) Apply ThreeBond 1102 to the both sides of front
plate packing and attach the packing to the front
face of crankcase. Secure front plate (1) with in­
jection pump installed with two bolts (2). The
tightening torque of the bolts is 2.1 kgm (15.2 lb.ft).
(b) Heat camshaft gear to 150
it to shaft.
(c) Slowly insert camshaft into crankcase.
° °
C to 180 C and fit
l
,
•
jJ