Pfaff creative 7550 Service Manual page 83

•
Insert the twelve-wire flat
•
Fit the complete programming
• two
Insert the screws 68, press the programming panel against the
and tighten the screws
• Install all cables according to the figure
e
Set the complete baseplate against the machine.
e
Insert motor plug 116 in motor socket 1 1 8 (both catches 117 must engage (fig. 36b)). Now the
flat cables are connected as follows t o the circuit board:
•
Two-connection plug 124 to the two pin
• The plug of five-wire flat cable 127 to the black pin base.
The plug of seven-wire flat cable 200 to the pink pin
•
• The plug of seven-wire flat cable 128 to the blue pin base.
• The plug of seven-wire flat cable 125 to the black pin
e
The plug of twelve-wire flat cable 121
The plug of five-wire flat cable 126 to the blue pin
•
The plug of four-wire flat cable 123 to the black pin
•
• Fold the baseplate against the machine and fasten
• Turn the machine in working position.
• Insert the five screws 40 and tighten them (fig. 36).
e
Tighten screw 128.
• Put the cap on the machine cover (fig. 36a).
e Fi t
the angle, insert the Torx screw, and set the angle by means of the
• Fit the handle with the retaining pin and the circlip (fig. 36).
Note:
Having exchanged the stepping motor for sideways needle movement, adjustment of the needle In
the needle hole, section 9, must
F rt
• the face cover and tighten it.
• Insert the housing insert and fasten
F rt
• the arm cover.
• Use testing appliance ABB Metrawatt M 5013
VDE 0701.
82
cable 121 downwards
panel correctly on the machine
(fig. 3Sc).
and
fit both
base.
to
the black pin base.
be
repeated.
it
with both screws.
to
in the machine.
housing.
machine housing,
.
cable clips
base.
base.
.
base
.
base
it
with the four screws.
top
carry out an electrical safety test according
cover.
to