Table of Contents
Advertisement
st
feed
4.
Ad
j
u
m
e
n
t of
Requirement:
In stitch program
"00",
equal (fig. 4).
Check:
·oo·.
In stitch program
Note:
adjustment
This
must only be carried
Adjustment:
• Remove needle and sewing foot.
e Unscrew baseplate and bobbin thread monitor, but leave all electrical connections in place.
on
• Switch
master
switch.
• Set
6
mm stitch length in stitch program •oo•.
Turn
handwheel by a complete turn.
•
• Loosen the three Philips screws
the feed dog is centered in the feed slots (fig. 4).
• Lightly tighten the 'three Philips screws
Crou-check:
• Press the staggered-stitch key.
• Press key
"3"
for maximum feed.
• Turn handwheel 8111 d check the distance of the feed dog
• If the adjustment is correct, tighten Philips screws
• Fit bobbin thread monitor and baseplate.
12
dog in sideways direction
the distance of the feed dog to the right and left. edges of the feed slot must be
carry out visual check of the feed dog position.
out
when compelling reasons exist
201
(fig. 4a) and turn the
201
(fig.
transverse-drive stepping
4a).
to
the left and right edges of th"
201
(fig. 4a).
motor
until
·<ed
slot.
Hide quick links:
Advertisement
Table of Contents
