Advertisement
1 4 3
0／1／2
／3
1 4 4
0~31
1 5 3
1～100
1 5 4
1～9999
1 5 5
0～4
1 6 1
0／1／2
1 6 2
1, 2
1 6 3
1, 2
1 6 4
-
2 0 3
5-359
2 0 4
10-359
2 0 A
10-60
2 1 1
5-359
2 1 2
10-359
2 1 3
1-999
2 1 4
1～999
2 1 5
0／1
2 1 6
1～999
2 1 7
1～9999
2 1 9
0／1
2 1 A
10-359
2 1 B
11-359
2 2 0
200～360
2 3 1
0／1
Special mode:
0: normal Mode
1: simply sewing mode
0
2: motor initial angle measurement (Do not remove the belt)
3: Automatically setting the pulley ratio by the CPU. (synchronizer is necessary
and the belt not removed)
Feedforward torque of motor:
0
0: normal functions
1-31: feedforward torque level
1
The proportion coefficient of the pieces counter
1
Maximum pieces of the counter
Count mode selection (For Sewing Piece)
0: The counter is invalid
1: Count up by pieces. When count over, counter will be auto- reset.
2: Count down by pieces. When count over, counter will be auto- reset.
0
3: Count up by pieces. When count over, motor stops and the counter must be
reset by the external switch or the P key on the panel.
4: Count down by pieces. When count over, motor stops and the counter must
be reset by the external switch or the P key on the panel.
Direction of parameter transfer:
0: no action 1: from operation panel to controller 2: from controller to
operation panel.
Restore factory setting
Save current parameters as user-defined default parameters.
Password
Trimming output start angle TS (down needle position angle as the reference
10
point)
Trimming output end angle TE (Down needle position angle is the reference
120
and this value should be bigger than TS)
20
Motor torque improvement coefficient during trimming
Thread release output start angle LS (down needle position angle as the
25
reference point)
Thread release output end angle LE (Down needle position angle is the
350
reference and this value should be bigger than LS)
1
Thread release output start delay time T1 (ms)
10
Thread release output end delay time T2 (ms) after up needle position
1
Wiper function
10
Wiper output delay time (ms)
70
Wiper output time (ms)
0
Thread clamp function 0: disable
120
Thread clamp start angle
318
Thread clamp end angle
360
Stop position after trimming (motor can stop with a reverse angle)
0
Auto test mode:
0: disable
1: enable
1: enable
0: stitches mode
5/8
1: time mode
Advertisement
