Advertisement
Key
Name
One-shot-sewin
g selection
Free sewing
Multi-section
constant-stitch
sewing
Presser foot
lifting Mode
Trimming cycle
selection
Start back
tacking setting
key
End back
tacking setting
key
Stop position
key
Custom function
key
Increasing and
decreasing
motor speed
Up and down
keys
Soft start setting
key
In constant-stitch sewing： a. One shot to the pedal, automatic performed number of stitches of every
section.
b. Toe down the pedal again and again to finish rest the sections until it finish pattern.
1). As the pedal is toed down, machine will start sewing. Once the treadle returned to neutral,
machine will stop immediately.
2). As the pedal heeled back, the trimming cycle will be finished automatically.
Also known as fixed length seam, press this key, the system is to enter a multi section seam work
mode. The LCD screen
maximum 15 segment can be set, YY is the current number of pins, the maximum 99 pin can be set.
If the current number of X is set to 00, the total number of valid segments is (X-1).
Switch during all presser foot lifting mode when pressing the key. (No lifting, lifting after trimming
cycle
only, lifting at machine stop
cycle
both).
Enable or disable the trimming cycle.
Switch during all start tacking type when pressing. (No tacking, once tacking , double tacking
repeat tacking
). Tacking stitches A、B can be set using the
Switch during all end tacking type when pressing. (No tacking, once tacking , double tacking
repeat tacking
). Tacking stitches C、D can be set using the
When sewing midway stop, system upper / lower needle stop position by pressing the key,
that is up needle stop position, then press the key, show down needle stop. the sewing complete
trimming, the system will stop up needle position. Note: the H-43 panel without the key, the key
P
+
combination to achieve the function.
Special function according to the custom requirement.
The maximum motor speed can be adjusted using the keys.
Adjust the values in plus and minus state.
Soft start at the first seam is enabled (icon on) or disabled.
Description
is lit and displayed on the n X yy, where X is the current segment, the
only, lifting at machine stop
3/8
and after trimming
key and the
key.
key and the
key.
, 4
, 4
is lit,
Advertisement
