Removing The Processor - Dell OptiPlex 320 DCSM User Manual

Processor: Dell OptiPlex 320 User's Guide
Back to Contents Page
Processor
Dell™ OptiPlex™ 320 User's Guide

Removing the Processor

Installing the Processor
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
Removing the Processor
1. Follow the procedures in
2. Loosen the captive screw on each side of the heat sink assembly.
CAUTION: Despite having a plastic shield, the heat sink assembly may be very hot during normal
operation. Be sure that it has had sufficient time to cool before you touch it.
3. Rotate the heat sink assembly upward, and remove it from the computer.
1 heat sink assembly
2 captive screw housings (2)
NOTICE: Unless a new heatsink is required for the new processor, reuse the original heat sink assembly when you
file:///N|/For_lekha/For%20Deepa/Nadia/UG/A00/en/nadia-temp-working-jul19/Nadia_UG_A00/Output/mt_cpu.htm[5/22/2015 10:43:47 AM]
Before You Begin.