Installing Memory - Dell OptiPlex 320 DCSM User Manual

Memory: Dell OptiPlex 320 User's Guide
2 securing clip (2)
3. Remove the memory module.
To install memory, see
4. Replace the computer cover (see

Installing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body
before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface
on the computer chassis.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1. Follow the procedures in
2. Press out the securing clip at each end of the memory module connector.
1 connector
2 securing clips (2)
3 memory connector closer to processor
3. Align the notch on the bottom of the module with the crossbar in the connector.
file:///N|/For_lekha/For%20Deepa/Nadia/UG/A00/en/nadia-temp-working-jul19/Nadia_UG_A00/Output/memory.htm[5/22/2015 10:43:53 AM]
Installing Memory.
Replacing the Computer
Before You Begin.
Cover).