Table of Contents
Advertisement
Drives: Dell OptiPlex 320 User's Guide
2 floppy-drive cable
3 floppy-drive connector (FLOPPY)
5. Replace the drive panel by aligning its hinges and rotating it up until it snaps into place.
6. Replace the computer cover (see
7. Enter system setup and use the Diskette Drive option to enable your new floppy drive (see
8. Verify that your computer works correctly by running the Dell Diagnostics (see
CD/DVD Drive
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
replacing the cover.
Removing a CD/DVD Drive
1. Follow the procedures in
2. Remove the drive panel by sliding the drive release latch downward to open the panel, and then remove it from the
hinges.
3. Disconnect the power and data cables from the back of the drive.
4. Slide the drive release latch downward and hold it in place. Without releasing the latch, slide the CD/DVD drive out of
the computer.
1 CD/DVD drive
file:///N|/For_lekha/For%20Deepa/Nadia/UG/A00/en/nadia-temp-working-jul19/Nadia_UG_A00/Output/mt_drive.htm[5/22/2015 10:43:38 AM]
Replacing the Computer
Before You
Begin.
Cover).
Dell
Entering System
Diagnostics).
Setup).
Advertisement
Table of Contents
