EN
Troubleshooting / Recycling and disposal
Troubleshooting
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most cases the
problem can be solved quickly.
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed
by an authorised service centre or a similarly qualified specialist if you
cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Unsatisfactory
result
4. Excessive
vibration or
noise
Recycling and disposal
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your Local Authority or local store for recycling advice.
For further information visit www.recycle-more.co.uk.
The product comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
product is working properly. Recycle the package afterwards.
28
Possible cause
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical defect
to the product
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source
(e.g. generator) has
too low voltage
2.3. Air vents are blocked
3.1. Blade is worn /
damaged
3.2. Thickness of branches
exceeds capacity
4.1. Blade is dull /
damaged
4.2. Bolts/nuts are loose
TTB826HDC by TITAN
Solution
1.1. Connect to power
supply
1.2. Check by a specialist
electrician
1.3. Check by a specialist
electrician
2.1. Use a proper
extension cord
2.2. Connect to another
power source
2.3. Clean the air vents
3.1. Replace with a new one
3.2. Only cut branches
complying with the capacity
4.1. Replace with a new one
4.2. Tighten bolts/nuts