Calibrating The Touch Screen; Resetting Powertouch Iii; Selecting The Model Type - Kenwood Sovereign VR-5900 Connection And Setup Manual

Chapter Two : Setting Up PowerTouch III
After you install the batteries or reset PowerTouch III, you
need to calibrate the touch screen. The touch screen re-
sponds to pressure from the included stylus or your finger:
If you are replacing batteries and complete the battery re-
placement within 3 minutes, you do not need to calibrate
the screen; calibration is stored in memory.
If the screen's performance begins to change, you can
recalibrate it without resetting PowerTouch III by pressing
on the Setup menu. For more information about ac-
cessing this menu, see "Identifying Devices For PowerTouch
III Control" on page 40.
After "Calibrating the Touch Screen", the "Selecting the Model
Type" display appears automatically.
The model type selection is performed to let the PowerTouch
III recognize the type of the receiver you have.
Once the model type is selected, it does not have to be se-
lected again even after PowerTouch III is reset.

Calibrating the Touch Screen

To calibrate the touch screen, use the stylus to touch the
center of each of the calibration points displayed:
When you touch each calibration point, you should hear a
beep and see the next point, indicating that area of the screen
is now calibrated. If you do not hear a beep, touch the cali-
bration point until you do.
The touch screen is sensitive to pressure, not to movement.
Press firmly but gently on any touch screen element. The screen
will not respond if you simply brush the stylus or your finger
along the surface.

Selecting the Model Type

To set the model type:
1. Press the receiver's ON STANDBY button to turn it ON.
2. Aim the PowerTouch III towards the receiver and press
the in the display.
3. The receiver automatically transmits its type code to
PowerTouch III. When the PowerTouch III stores it, the
model type selection is complete.
Now the new PowerTouch III is available for operation.
• If the model type cannot be selected automatically be-
cause the receiver is not ON, etc., the model type can be
selected manually. In this case, select the "Model 1" in
step 2 above.

Resetting PowerTouch III

If you want to reconfigure PowerTouch III, you can reset it.
You do not need to do this unless you experience a prob-
lem.
1. Open the cover.
2. Use the stylus to press the blue button at the bottom of
the battery case:
RESET
The items you set up in this chapter will remain in
PowerTouch III. If you want to make it to the factory–set
default condition, please follow the instructions on page
104 of the Users' Guide.
If you committed mistake in the model type selection, re-
start it as follows.
• While holding the CONFIRM and VOLUME DOWN
buttons together, press and release the RESET button
under the battery cover (see above diagram). Do not
release the CONFIRM and VOLUME DOWN buttons
until a short beep indicating the completion of setting
is heard.
After the above, all settings are reset to the factory set-
tings.
35