Calibrating The Touch Screen; Resetting Powertouch - Kenwood VR-4900 Connection And Setup Manual

Chapter Two : Setting Up PowerTouch
After you install the batteries or reset PowerTouch, you need
to calibrate the touch screen. The touch screen responds to
pressure from the included stylus or your finger:
If you are replacing batteries and complete the battery re-
placement within 3 minutes, you do not need to calibrate
the screen; calibration is stored in memory.
If the screen's performance begins to change, you can
recalibrate it without resetting PowerTouch by pressing
on the Setup Preference menu. For more information
about accessing this menu, see "Identifying Devices For
PowerTouch Control" on page 37.
After "Calibrating the Touch Screen", the "Selecting the Model
Type" display appears automatically (Except for KRF-
V9993D). (This is not displayed when the model type has
already been set.)

Calibrating the Touch Screen

To calibrate the touch screen, use the stylus to touch the cen-
ter of each of the calibration points displayed:
When you touch each calibration point, you should hear a
beep and see the next point, indicating that area of the screen
is now calibrated. If you do not hear a beep, touch the cali-
bration point until you do.
The touch screen is sensitive to pressure, not to movement.
Press firmly but gently on any touch screen element. The screen
will not respond if you simply brush the stylus or your finger
along the surface.
Selecting the Model Type
To set the model type:
1. Press the receiver's ON STANDBY key to turn it ON.
2. Point the PowerTouch to the receiver and press the
in the display.
3. The receiver automatically transmits its type code to
PowerTouch. When the PowerTouch stores it, the model
type selection is complete.
Now the new PowerTouch is available for operation. The
"Quick Tour" is the initial display after the batteries have
been loaded.
• If the model type cannot be selected automatically be-
cause the receiver is not ON, etc., the model type can be
selected manually. In this case, refer to the table on the
right and select the correct model type in step 2 above.

Resetting PowerTouch

If you want to reconfigure PowerTouch, you can reset it.
You do not need to do this unless you experience a prob-
lem.
1. Open the cover.
2. Use the stylus to press the blue button at the bottom of
the battery case:
RC-R1110: RC-R1010:
(For VR-4900/VR-4700) (For KRF-V9993D)
RESET
RESET
The items you set up in this chapter will remain in
PowerTouch. If you want to make it to the factory–set de-
fault condition, please follow the instructions on page 98/
99 of the Users' Guide.
Use this model
If you have this receiver...
type...
VR-4900
MODEL 1
VR-4700
MODEL 2
KRF-V9993D
MODEL 3
If you committed mistake in the model type selection, re-
start it as follows.
• While holding the CONFIRM and VOLUME DOWN keys
together, press and release the RESET button under the
battery cover (see above diagram). Do not release the
CONFIRM and VOLUME DOWN keys until a short beep
indicating the completion of setting is heard.
After the above, all settings are reset to the factory set-
tings.
33