To Connect A Cd-R Recorder - Kenwood Sovereign VR-5900 Connection And Setup Manual

Chapter One : Connecting Your Devices
Do not plug in the receiver to AC power until you have
connected all your devices.
This section focuses on the connections from your CD-R
recorder to the VR-5900. Please refer to your CD-R recorder
instructions for more detail about its connection jacks and
capabilities.
Each set of instructions in this section shows one of several
possible variations on connecting your CD-R recorder. For
further assistance on optional configurations, contact the
store where you purchased your CD-R recorder.
Connecting Your CD-R Recorder, continued

To Connect a CD-R Recorder:

1. Connect the audio cable from the CD-R recorder's Play
OUT jacks to the receiver's CD-R PLAY IN jacks as shown
to the left.
2. Connect the audio cable from the CD-R recorder's Rec
IN jacks to the receiver's CD-R REC OUT jacks, as shown
to the left.
3. Connect the digital cable (either optical or coaxial) from
the CD-R's digital jack to the appropriate digital jack on
the receiver as shown to the left.
The illustration shows two digital connections, one for
coaxial connection and one for optical connection. Your
CD-R recorder supports one or the other of these con-
nection methods—do not connect both.
You only need to connect to the digital output jack if
you will be recording from sources that are connected
to a digital input jack, such as a CD or DVD player.
4. Go to "Noting Your Devices" on page 3 and note which
jacks you used to connect your CD-R recorder. In addi-
tion, note the brand name and model number of the
CD-R recorder.
21