To Connect An Cd-R Recorder - Kenwood VR-4090 Instruction Manual

Chapter One : Connecting Your Devices
Do not plug in the receiver to AC power until you have
connected all your devices.
This section focuses on the connections from your CD-R
recorder to the VR-4090/VR-4080/KRF-V7773D. Please re-
fer to your CD-R recorder instructions for more detail about
its connection jacks and capabilities.
Each set of instructions in this section shows one of several
possible variations on connecting your CD-R recorder. For
further assistance on optional configurations, contact the
store where you purchased your CD-R recorder.
Connecting Your CD-R Recorder, continued

To Connect an CD-R Recorder:

1. Connect the audio cable from the CD-R recorder's Play
OUT jacks to the receiver's CD-R PLAY IN jacks as shown
to the left.
2. Connect the audio cable from the CD-R recorder's Rec
IN jacks to the receiver's CD-R REC OUT jacks, as shown
to the left.
3. (VR-4090 only:) When the CD-R recorder has digital
jacks, connect digital (coaxial or optical) cables between
the CD-R recorder's digital jacks and the receiver's CD-
R digital jacks, as shown to the left. (Although the fig-
ure shows both the coaxial cable connection and opti-
cal cable connection, use either connection in actual
case.)
When connecting a digital optical cable, remove the
protect covers from the optical jacks.
You only need to connect to the digital out jack if you
will be recording from sources that are connected to a
digital in jack, such as a CD or DVD player.
4. Go to "Noting Your Devices" on page 3 and note which
jacks you used to connect your CD-R recorder. In addi-
tion, note the brand name and model number of the
CD-R recorder.
19