Intermec EasyCoder PF4i User Manual page 90

Displayed Error Messages and LED Indicators (continued)
EasyCoder PF4i User's Guide (IPL Version)
Error/Event
Pause mode entered
Setup mode entered
IP link error
IP configuration error
Printhead not found
Rebooted
Initializing
Printer crash
Printer turned off
Maintenance
Power supply over
temperature
Printhead hot
Note 1: This is only applicable for printers equipped with an
EasyLAN interface.
Note 2: A printer that is equipped with an EasyLAN interface,
but is not connected to a network, will have a blinking RTW. To
avoid this, set "IP SELECTION" to "MANUAL" and "IP
ADDRESS" to "0.0.0.0". This will indicate that the lack of
network connection is not an error.
Note 3: No trap can be sent when this error/event occurs.
Note 4: This error indicates that the printer has not received an
IP address. It is only applicable for printers with IP
SELECTION set to DHCP and/or BOOTP.
Chapter 8 — Troubleshooting
RTW Displayed Error
Status Message
Blink PAUSED
Blink
Blink
Blink
Off NO
PRINTHEAD
Off
Off
Off
Off
Off
Off PSU OVER
TEMP
Off PRINTHEAD
HOT
Comment
Including
interactive
setup.
See notes 1, 2,
and 3 below.
See notes 1, 3,
and 4 below.
Appears at
startup until
printer is
operational.
See notes 3
and 5 below.
Appears when
upgrading.
See note 6
below.
75